Re: Dom0 crashing when built with c/s 881 (Was: [Xen-devel] blktap2: need more than 3 values to unpack)

[Isaku Yamahata <yamahata@xxxxxxxxxxxxx>]

On Thu, Jun 04, 2009 at 01:18:14PM +0900, Isaku Yamahata wrote:
> On Wed, Jun 03, 2009 at 03:12:10PM -0700, Dan Magenheimer wrote:
> > > Actually I missed that the dependent code is only built if
> > > CONFIG_PCI_IOMULTI && CONFIG_HOTPLUG_PCI. You've probably got 
> > > one or both
> > > disabled and hence 882 doesn't break without 881 in your case.
> > 
> > In case it helps, with 889 and 881 reverted, I am using the
> > default config which results in CONFIG_PCI_IOMULTI=y and
> > CONFIG_HOTPLUG_PCI=m.
> 
> Ah, I tested it with CONFIG_HOTPLUG_PCI=y.
> So does it make difference to set it =y instead of =m?

CONFIG_HOTPLUG_PCI=m works for me.
The 'use bus_type' message wasn't printed out.

-- 
yamahata

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel