[Xen-devel] Running out of Xen heap space with large memory

[beth kon <eak@xxxxxxxxxx>]

Hi. I have been debugging a hang when booting Xen with 512G memory. I am 
testing on an x3950, 8 nodes, 128 way, with xen 3.0.3.  In order to get 
past the 166G limit, IETH added the no-pv-compat flag to the xen boot line.
The boots have been hanging when memory is greater than about 432G. I 
found that, as memory size increases, the size of the xen heap 
decreases, because additional memory is being used for the memory 
housekeeping (seen in init_boot_allocator). Eventually (around 432G) the 
xen heap is reported as 0MB:
(XEN) Command line: /xen.gz-2.6.18-53.el5 numa=on dom0_mem=512m com2=19200,8n1
console=com2 no-pv-compat
(XEN)  0000000000000000 - 0000000000098000 (usable)
(XEN)  0000000000098c00 - 00000000000a0000 (reserved)
(XEN)  00000000000e0000 - 0000000000100000 (reserved)
(XEN)  0000000000100000 - 000000007fea6000 (usable)
(XEN)  000000007fea64c0 - 000000007fef6380 (ACPI data)
(XEN)  000000007fef6380 - 0000000090000000 (reserved)
(XEN)  00000000fec00000 - 0000000100000000 (reserved)
(XEN)  0000000100000000 - 0000007e00000000 (usable)
(XEN) System RAM: 514046MB (526383352kB)
(XEN) ACPI: [SRAT:0x00] ignored 32 entries of 64 found
(XEN) BETH xenheap_phys_start = 18677760, xenheap_phys_end=16777216
(XEN) BETH s = 4294967296, e=16777216
(XEN) Xen heap: 0MB (0kB)
(XEN) Cannot handle page request order 2!
(XEN) Cannot handle page request order 0!
(XEN) Unknown interrupt

The boot hangs at this point (no surprise). Note that the "BETH" debug 
statements show xenheap_phys_start>xenheap_phys_end.
I realize that interest in this may be low since the no-pv-compat flag 
has been removed in xen-unstable. The resulting 166G limit was discussed 
here:
http://lists.xensource.com/archives/html/xen-devel/2007-08/msg00493.html

If pages being passed among domains is the issue, wouldn't the 
no-pv-compat flag address that by not allowing any 32 bit guests on the 
machine? I assume page stealing is restricted to domains running on the 
same hypervisor, right? Why was the no-pv-compat flag removed?
And as Raj discussed:
http://lists.xensource.com/archives/html/xen-devel/2007-10/msg00550.html
Even if Raj provides these changes, I believe the above issue with 
running out of heap space would still exist.  I see that 
init_boot_allocator is unchanged between 3.0.3 and unstable. Any 
suggestions on how this issue could be corrected?
I will continue to look at this code, but any suggestions from people 
who are more familiar with it would be greatly appreciated.
--

Elizabeth Kon (Beth)
IBM Linux Technology Center
Open Hypervisor Team
email: eak@xxxxxxxxxx


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel