| |
|
 |
|
 |
|
|
|
| |
|
|
xen-devel
RE: [Xen-devel] [PATCH 6/10] Allow vcpu to pause self
>From: Keir Fraser [mailto:keir@xxxxxxxxxxxxx]
>Sent: 2007年7月12日 1:02
>
>On 27/6/07 14:37, "Tian, Kevin" <kevin.tian@xxxxxxxxx> wrote:
>
>> Add self pause ability, which is required by vcpu0/dom0 when
>> running on a AP. This can't be satisfied by existing interface,
>> since the new flag also serves as a sync point.
>>
>> Signed-off-by Kevin Tian <kevin.tian@xxxxxxxxx>
>
>I think this should not be needed. Why is dom0/vcpu0 special at all? If
>you
>are doing the final work from a softirq context, can't dom0/vcpu0 simply
>be
>paused like all others at that point? If not then we'll need to make some
>arrangement using vcpu_set_affinity() - I won't add another flag on the
>context-switch path.
I tried to recall the reason for adding this flag. The major reason is that
sleep hypercall happens on dom0/vcpu0's context, while actual
enter_state may happen in softirq on idle vcpu context. As a result, we
need to update rax as return value to dom0/vcpu0 which means lazy
state required flush into per-vcpu guest context before updating.
However existing vcpu_pause doesn't work on self context and
vcpu_pause_nosync leaves lazy state there. That's why a new flag is
added to allow lazy context sync-ed after switching out.
But after a further thinking, based on the fact that enter_state will force
a lazy context flush on all CPUs now, this interface can be abandoned
then.
>
>So currently patches 6,7,9,10 are not applied. Patches 6 & 7 because
>they
>need more iteration, as commented above. Patches 9 & 10 will likely
>change
>when the platform_op hypercall interface is slimmed down, so I'm
>leaving
>them out for now.
I'll resend later.
>
>All other patches are in (although the platform_op interface part of patch
>2
>is disabled).
>
Thanks so much,
Kevin
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
|
|
|
| |
|
Home