[Xen-users] Re: [Xen-API] bnx2 driver failed in linux-2.6.18.8-xen-3.4.2, Dell R610

[Bruce Edge <bruce.edge@xxxxxxxxx>]

On Fri, Nov 12, 2010 at 12:10 PM, Luwei Cheng <chengluwei@xxxxxxxxx> wrote:
> So many issues I did not expect to have... I think I need a 2.6.18 stable
> kernel to run.
> Actually I have only ONE step to succeed in 2.6.18.8. Any one who knows how
> to patch bnx2 dirver?
> Deep thanks!
> --Luwei
>
> On Sat, Nov 13, 2010 at 2:05 AM, Luwei Cheng <chengluwei@xxxxxxxxx> wrote:
>>
>> Yes, I am already in progress to install 2.6.32 with long time to git
>> clone... hope not too much trouble shooting:-)
>> Anyway, if there's any patch to 2.6.18.8-bnx2 driver, I'd like it more.
>> Regards,
>> Luwei

Not sure if this is related to your specific problem, but to use a
BNX2 NIC I need to enable
    CONFIG_FIRMWARE_IN_KERNEL=y
in order to pull the BNX2 firmware into the kernel, otherwise it
complains that it can't find the firmware at boot time.

-Bruce

>>
>> On Sat, Nov 13, 2010 at 1:56 AM, Konrad Rzeszutek Wilk
>> <konrad.wilk@xxxxxxxxxx> wrote:
>>>
>>> On Sat, Nov 13, 2010 at 01:19:03AM +0800, Luwei Cheng wrote:
>>> > Hello Konrad,
>>> >
>>> > Thanks for your reply to enlighten me.
>>> >
>>> > This is almost the first time that I compile XenLinux from source. To
>>> > play
>>> > safe, I just downloaded the source code from www.xen.org.
>>> > Is 2.6.32-PVOPS already stable kernel? Is there any document to follow
>>> > so
>>> > that I won't miss some steps? Thanks!
>>>
>>> Look on Google for "Wiki PVOPS" and it will direct you the Wiki on how to
>>> do it.
>>
>
>
> _______________________________________________
> xen-api mailing list
> xen-api@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/mailman/listinfo/xen-api
>
>

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users